40 lines
2.2 KiB
Markdown
40 lines
2.2 KiB
Markdown
# Stepper_TB6612
|
|
|
|
This is a derived class of **StepperControl** designed to operate stepper motors driven by a [Toshiba TB6612](https://cdn-shop.adafruit.com/datasheets/TB6612FNG_datasheet_en_20121101.pdf) chip, either with or without the use of ESP32 PWM pins. To use, add `#include "extras/Stepper_TB6612.h"` to the top of your sketch.
|
|
|
|
The Toshiba TB6612 is a generic motor driver providing direct control of two full H-bridges. Wiring for the [Adafruit Motor Driver](https://learn.adafruit.com/adafruit-tb6612-h-bridge-dc-stepper-motor-driver-breakout) board that uses this chip is as follows:
|
|
|
|
#### **Power Connections**
|
|
* *VCC* - connect to +3.3V on ESP32
|
|
* *VM+* - connect to external DC power supply that will drive stepper motor (5-13V)
|
|
* *GND* - connect to GND on the ESP32, and to ground of external DC power supply
|
|
#### **Motor Connections**
|
|
* *MOTORA* - connect to the "A" coil of the stepper motor
|
|
* *MOTORB* - connect to the "B" coil of the stepper motor
|
|
#### **Control Connections**
|
|
* *AIN1, AIN2* - connect to two digital pins on the ESP32 - used to control direction and state of coil *A*
|
|
* *BIN1, BIN2* - connect to two digital pins on the ESP32 - used to control direction and state of coil *B*
|
|
* *PWMA, PWMB* - if using PWM, connect to two digital pins on the ESP32; if not, connect to +3.3V on ESP32 to pull high
|
|
* *STBY* - connect to +3.3V on ESP32 to pull high
|
|
|
|
The **Stepper_TB6612** class includes two constructors:
|
|
* `Stepper_TB6612(int AIN1, int AIN2, int BIN1, int BIN2)`
|
|
* controls the driver board using only 4 digital pins from the ESP32, where the parameters specify the pin numbers. Supports the following step type modes:
|
|
|
|
* FULL_STEP_ONE_PHASE
|
|
* FULL_STEP_TWO_PHASE
|
|
* HALF_STEP
|
|
|
|
* `Stepper_TB6612(int AIN1, int AIN2, int BIN1, int BIN2, int PWMA, int PWMB)`
|
|
* controls the driver board using 4 digital pins and 2 PWM pins from the ESP32, where the parameters specify the pin numbers. Supports the following step type modes:
|
|
|
|
* FULL_STEP_ONE_PHASE
|
|
* FULL_STEP_TWO_PHASE
|
|
* HALF_STEP
|
|
* QUARTER_STEP
|
|
* EIGHTH_STEP
|
|
|
|
---
|
|
|
|
[↩️](../Stepper.md) Back to the Stepper Motor Control page
|