diff --git a/User_Setup.h b/User_Setup.h
index 829b1dc..6a1e913 100644
--- a/User_Setup.h
+++ b/User_Setup.h
@@ -129,9 +129,9 @@
 // ###### EDIT THE PIN NUMBERS IN THE LINES FOLLOWING TO SUIT YOUR ESP8266 SETUP ######
 
 // For NodeMCU - use pin numbers in the form PIN_Dx where Dx is the NodeMCU pin designation
-//#define TFT_CS   PIN_D8  // Chip select control pin D8
-//#define TFT_DC   PIN_D3  // Data Command control pin
-//#define TFT_RST  PIN_D4  // Reset pin (could connect to NodeMCU RST, see next line)
+#define TFT_CS   PIN_D8  // Chip select control pin D8
+#define TFT_DC   PIN_D3  // Data Command control pin
+#define TFT_RST  PIN_D4  // Reset pin (could connect to NodeMCU RST, see next line)
 //#define TFT_RST  -1    // Set TFT_RST to -1 if the display RESET is connected to NodeMCU RST or 3.3V
 
 //#define TFT_BL PIN_D1  // LED back-light (only for ST7789 with backlight control pin)
@@ -164,17 +164,17 @@
 // For ESP32 Dev board (only tested with ILI9341 display)
 // The hardware SPI can be mapped to any pins
 
-#define TFT_MISO 19 // Matching T_DO
-#define TFT_MOSI 23 // Matching T_DIN
-#define TFT_SCLK 18 // Matching T_CLK
-#define TFT_CS   17  // Chip select control pin
-#define TFT_DC   16  // Data Command control pin
-#define TFT_RST   5  // Reset pin (could connect to RST pin)
+//#define TFT_MISO 19
+//#define TFT_MOSI 23
+//#define TFT_SCLK 18
+//#define TFT_CS   15  // Chip select control pin
+//#define TFT_DC    2  // Data Command control pin
+//#define TFT_RST   4  // Reset pin (could connect to RST pin)
 //#define TFT_RST  -1  // Set TFT_RST to -1 if display RESET is connected to ESP32 board RST
 
-#define TFT_BL   32  // LED back-light (only for ST7789 with backlight control pin)
+//#define TFT_BL   32  // LED back-light (only for ST7789 with backlight control pin)
 
-#define TOUCH_CS 21     // Chip select pin (T_CS) of touch screen
+//#define TOUCH_CS 21     // Chip select pin (T_CS) of touch screen
 
 //#define TFT_WR 22    // Write strobe for modified Raspberry Pi TFT only
 
@@ -283,4 +283,4 @@
 // Transactions are automatically enabled by the library for an ESP32 (to use HAL mutex)
 // so changing it here has no effect
 
-// #define SUPPORT_TRANSACTIONS
+// #define SUPPORT_TRANSACTIONS
\ No newline at end of file