diff --git a/User_Setup.h b/User_Setup.h index 9014b8a..a678855 100644 --- a/User_Setup.h +++ b/User_Setup.h @@ -36,7 +36,7 @@ //#define RPI_DISPLAY_TYPE // 20MHz maximum SPI // Only define one driver, the other ones must be commented out -#define ILI9341_DRIVER +//define ILI9341_DRIVER //#define ST7735_DRIVER // Define additional parameters below for this display //#define ILI9163_DRIVER // Define additional parameters below for this display //#define S6D02A1_DRIVER @@ -44,7 +44,7 @@ //#define HX8357D_DRIVER //#define ILI9481_DRIVER //#define ILI9486_DRIVER -//#define ILI9488_DRIVER // WARNING: Do not connect ILI9488 display SDO to MISO if other devices share the SPI bus (TFT SDO does NOT tristate when CS is high) +#define ILI9488_DRIVER // WARNING: Do not connect ILI9488 display SDO to MISO if other devices share the SPI bus (TFT SDO does NOT tristate when CS is high) //#define ST7789_DRIVER // Full configuration option, define additional parameters below for this display //#define ST7789_2_DRIVER // Minimal configuration option, define additional parameters below for this display //#define R61581_DRIVER @@ -189,15 +189,15 @@ // For ESP32 Dev board (only tested with ILI9341 display) // The hardware SPI can be mapped to any pins -//#define TFT_MISO 19 -//#define TFT_MOSI 23 -//#define TFT_SCLK 18 -//#define TFT_CS 15 // Chip select control pin -//#define TFT_DC 2 // Data Command control pin -//#define TFT_RST 4 // Reset pin (could connect to RST pin) +#define TFT_MISO 19 +#define TFT_MOSI 23 +#define TFT_SCLK 18 +#define TFT_CS 5 // Chip select control pin +#define TFT_DC 17 // Data Command control pin +#define TFT_RST 16 // Reset pin (could connect to RST pin) //#define TFT_RST -1 // Set TFT_RST to -1 if display RESET is connected to ESP32 board RST -//#define TOUCH_CS 21 // Chip select pin (T_CS) of touch screen +#define TOUCH_CS 4 // Chip select pin (T_CS) of touch screen //#define TFT_WR 22 // Write strobe for modified Raspberry Pi TFT only