Eliminated constructor that had no pin parameter. Pin parameter is now always required. Since PushButton was not part of HomeSpan API, these changes should not impact any users.
Optional method to automatically turn off Status LED after a *duration* seconds. LED will resume normal operation any time it is re-triggered with a new pattern. This also resets the elapsed time used to check for autoOff.
The update from Arduino-ESP32 2.0.0 to 2.0.1 contained significant changes to the structures used by the IDF for generic timers. This broke the Blinker code (would not compile for ESP32-S2 and C3 chips).
The solution: Modified Blinker::isrTimer() to use a *generic* interrupt-clearing function when available (IDF version >= 4.0.0). Below 4.0.0 the code continues to manually clear the interrupt flag by resetting specific structure variables, though the logic is simpler since this is only needed for the ESP32 chip (the S2 and C3 are not supported in earlier versions of Arduino-ESP32).
This provides for full compatibility with Arduino-ESP32 versions 2.0.1, 2.0.0, and 1.0.6. The use of a generic interrupt clearing function when IDF>=4.0.0 will hopefully make this future-proof to any further changes by Espressif to the underlying timer structures.
Re-worked code to allow for NO Status LED Pin and NO Control Pin. If Control Pin is not set explicitly with homeSpan.setControlPin(), there will be no Control Pin. There is no longer a default since there are too many board variations with S2 and C3 chips now supported. Same for Status Pin - it will not be defined unless set explicitly with homeSpan.setStatusPin(), with the exception that if LED_BUILTIN is defined (i.e. there is a built-in LED), then the Status LED Pin will default to LED_BUILTIN if not explicitly defined. MUST UPDATE DOCUMENTATION - THIS CHANGES DEFAULT BEHAVIOR OF HOMESPAN AND MAY REQUIRE UPDATES TO EXISTING SKETCHES
moved gpio_set_direction to start() method so that it is called every time needed in case another part of the program (i.e. DEV_Identify) calls pinMode() and resets the pin to a strict OUTPUT.
This allows the Serial Monitor to send NL or CR/NL at end of each line. A newline ('\n') must be at the end to terminate reading from the Serial Monitor, but any preceeding carriage returns are stripped out.
button(int pin, boolean isLong) changed to button(int pin, int pressType), where pressType can be SpanButton::LONG, SpanButton::SINGLE, or SpanButton::DOUBLE. Updated Example 16 and confirmed everything works as expected.
To do: Review all prior examples and update SpanButton when needed. Also need to update Zephyr Vent Hood code!
The 'A' command now resets any existing WiFi functionality so that it can start an Access Point without needing to first reboot.
To Do: Add a method to cancel out of apConfigure() and reboot by pressing control button.
To Do: Create time-out for commandMode()
No need for any new methods - default is now that longPress repeats every longTime milliseconds provided button continues to be held down. Once a longPress is triggered, a shortPress will not be triggered until button is released.
Created separate init() methods for PushButton and Blinker. Created HomeSpan:setControlPin and HomeSpan:setStatusPin that can be called from main setup() to modify the defaults. All default settings being migrated to Settings.h
Gregg