From b43e670ed86a834001e32d672ace77555dd25f13 Mon Sep 17 00:00:00 2001 From: HomeSpan Date: Mon, 4 Jan 2021 07:40:38 -0600 Subject: [PATCH] Update UserGuide.md --- docs/UserGuide.md | 14 +++++--------- 1 file changed, 5 insertions(+), 9 deletions(-) diff --git a/docs/UserGuide.md b/docs/UserGuide.md index 312ff78..4f45982 100644 --- a/docs/UserGuide.md +++ b/docs/UserGuide.md @@ -31,8 +31,6 @@ If you are new to HomeSpan and are configuring a new device for the first time, If you are setting up an existing device that has been previously configured in some unknown fashion, you may want to first perform a [Factory Reset](#factory-reset) to start with a fresh setup. -And if you run into any troubles, see [Troubleshooting](#troubleshooting) for tips and tricks. - Enjoy! ## HomeSpan Device States @@ -53,9 +51,12 @@ If the Status LED is steady ON, the device is connected to a local WiFi network #### CONNECTING -If the Status LED is repeatedly flashing ON for 1 second and then OFF for 1 second, the device is actively seeking to connect to a WiFi network using the WiFi Credentials stored on the device. The device will remain in this state until HomeSpan either successfully connects to a WiFi network, or you cancel the connection process. +If the Status LED is repeatedly flashing ON for 1 second and then OFF for 1 second, the device is actively seeking to connect to a WiFi network using the WiFi Credentials stored on the device. The device will remain in this state until HomeSpan either + +* successfully connects to a WiFi network +* you modify or erase the device's WiFi Credentials and restart HomeSpan via the Device Configuration Mode below +* you perform a [Factory Reset](#factory-reset) -To cancel the connection process, press and hold the HomeSpan Control Button for 3 seconds, at which point the Status LED should begin to flash rapidly (10 times per second). Upon releasing the Control Button, HomeSpan will erase the WiFi Credentials stored and reboot the device in the **NO‑WIFI** state. Note that the Status LED is always active, so if the LED is completely off (not even blinking), the device is not powered! ## Device Configuration Mode @@ -156,11 +157,6 @@ The box can be bigger or smaller as long as you keep the same proportions. For Note that if you can’t find *Scancardium* listed as a font choice in either the *Pages* or *Keynote* font dropdown boxes, select Format → Font → Show Fonts from the menu bar of the *Pages* or *Keynote* application to bring up a list of all installed fonts where you can search for, and select, *Scancardium*. -## Troubleshooting - -This section contains potential solutions to common problems. -(coming soon) - --- [↩️](README.md) Back to the Welcome page